@article{MARTINEZ2018675,
title = "Experimental study of the energy and exergy performance of a plastic mesh evaporative pad used in air conditioning applications",
journal = "Applied Thermal Engineering",
volume = "138",
pages = "675 - 685",
year = "2018",
issn = "1359-4311",
doi = "https://doi.org/10.1016/j.applthermaleng.2018.04.065",
url = "http://www.sciencedirect.com/science/article/pii/S1359431117378225",
author = "P. Martínez and J. Ruiz and P.J. Martínez and A.S. Kaiser and M. Lucas",
keywords = "Evaporative cooling, Cooling efficiency, Exergy efficiency, Pressure drop",
abstract = "This paper experimentally studies the thermal and fluid-dynamic behaviour of a new type of evaporative pad made from a high-density polyethylene mesh. Three different pad sizes with dimensions of 492 × 712 mm and thicknesses of 80, 160, and 250 mm are tested. The experiments are conducted in a subsonic wind tunnel adapted to recirculate water on the pads by a pump-driven circuit. A complete set of tests are carried out in which the cooling pad operating parameters such as air flow velocity, water flow rate and pad thickness are varied. As a result, the values of the following characteristic variables of the cooling pad are obtained: saturation efficiency, energy efficiency, exergy efficiency, pressure drop, humidity ratio variation, air temperature variation and amount of evaporated water. The results show that the maximum saturation efficiency of this type of pad is 80.5% and the maximum pressure drop in the air flow is less than 17 Pa. In addition, it is established that the behaviour of exergy efficiency is opposite to the expected function of the evaporative pad and varies from 70% to 94% with decrease in pad thickness. Finally, a new overall exergy efficiency is proposed in this study to optimize the operating conditions of the evaporative pad in air conditioning applications."
}